I-Tech Company CMS 6R4 Series User Manual
Page 73
6-9
Operation
2. Third Party Disconnection: (Supervisor Mode Only) The /D command
is issued from your resident port to disconnect two third party ports. For
example, if your Resident Port is Port 1, a Third Party Disconnection
could be used to disconnect Port 3 from Port 4.
Note:
The Third Party Disconnect method can be used to terminate
a Telnet "Direct Connection" or an outbound Telnet connection. For
more information, please refer to Section 6.6.
a) The /D command uses the format:
/D x X [Enter], where x and X
are the numbers of the ports that you wish to disconnect.
b) The /D (Disconnect) command can only be invoked by passwords
and ports that permit access to Supervisor Level commands.
c) The /D command can specify both connected ports, or either of the
two ports. For example, if Port 1 is your resident port, any of the
following commands can be used to disconnect Port 3 from Port 4:
/D 3 4 [Enter]
or
/D 3 [Enter]
or
/D 4 [Enter]