Fostex VF-16 - Manual (Page 90)

90
You can select any existing program available on the
current drive by rotating the [JOG] dial besides "New
PGM". When selecting an existing program, the data
size of the current program is also shown.
When you select load data to an existing program, the
backup data overwrites the existing data.
If you do not like any track to be overwritten, select
"New PGM".
If the current drive disk (destination disk of loading data)
does not have enough available space for accepting the
loaded data, The display shows "Disk Full" and the
returns to the screen shown when carrying out step 3.
flashing
flashing
You can select any existing program available on the
current drive by rotating the [JOG] dial besides "New
PGM".
When selecting an existing program, the data size of
the program is also shown.
When you load the data to any existing program, the
backup data overwrites the existing data.
If you do not like to overwrite any track, select "New
PGM".
If the current drive disk (destination disk of loading data)
does not have enough available space for accepting the
loaded data, The display shows "Disk Full" and the
returns to the screen shown when carrying out step 3.
5. Use the [JOG] dial to select the load destination
program and press the [ENTER/YES] key.
The data load to the selected program starts.
The following screen example shows that the "B01" data
on the backup disk is now being loaded to "P02" on the
current disk. As the data load goes on, the remaining
data size shown on the screen counts down.
You cannot abort the load operation before completed
using SCSI, unlike the load operation using the S/PDIF
or adat signal.
When the load operation is completed, "Completed!"
appears, while the VF-16 stops.
6. Press the [EXIT/NO] key (or the [STOP] key) repeatedly
until exiting the Setup mode.
Loading from more than one disk
The following procedure shows how to load song
data saved to two SCSI disks.
1. Insert the first disk (Disk-1) to the SCSI device.
2. Carry out the same procedures as steps 1 through 3
described in the previous section "Loading from a
single disk".
The display shows the screen for selecting a program
loaded.
If the program is saved over more than one disks, backup
file number "B01" flashes, as well as the recorded data
size is shown.
• By using the [JOG] dial in this step, you can select
"Eject" as well as destination programs. To eject
the disk, select "Eject" and press the [ENTER/YES]
key.
If Disk-2 (the second disk when saving) is inserted in
mistake, the VF-16 automatically recognized that the
wrong disk is set. The display shows "Wrong Disk",
followed by "Illegal No!", and the disk is automatically
ejected. Then, as the display shows "Insert Disk", insert
Disk-1.
3. Press the [ENTER/YES] key.
The display shows the screen for selecting the
destination program to which data is loaded.
In the default setting, "New PGM" is selected so that the
data is loaded to a newly created program.