Fostex VF-16 - Manual (Page 118)

118
Maintenance
Specifications
Recording/Reproducing
Recording Medium : 3.5 inch, hard disk (E-IDE type)
Recording Format : FDMS-3 (*)
Save/Load Format : FDIO-1 (**)
Sampling Frequency : 44.1kHz
Quantization : 16-bit linear (Non expanded)
A/D Converter : 20-bit 64 times, over sampling, Delta-Sigma
D/A Converter : 24-bit 128 times, over sampling, Delta-Sigma
No. of Recording Track : 16 real tracks + 8 additional tracks
*16 tracks for simultaneous recording
Vari Pitch Control : +/- 6%
Crossfade : 10msec.
Recording/Reproducing Frequency : 20Hz ~ 20kHz
Input/Output
Input 1 ~ 6
Connector : ø6mm Phone jack (Unbalanced)
Input Impedance : 50k Ω or more (Unbalanced)
Standard Input Level : -50dBV ~ 2dBV
Input 7 and 8
Connector : ø6mm Phone jack (Unbalanced)
: XLR-3-31 type (Balanced)
Input Impedance : 50k Ω or more (Unbalanced), 10k Ω or more (Balanced)
Standard Input Level : -50dBV ~ 2dBV
Phantom Power (XLR only) : +48VDC (Setting of ON/OFF with SETUP mode)
Output (Tip)
Load Impedance
: 10k Ω or more
Input Level : -10dBV
INSERT Input/Output
Connector : ø6mm TRS Phone jack
Output (Tip)
Load Impedance : 10k Ω or more
Input Level : -10dBV
Input (Ring)
Load Impedance : 10k Ω or more
Output Level : -10dBV
MONITOR Output
Connector : ø6mm Phone jack (Unbalanced)
Load Impedance : 10k Ω or more
Output Level : -10dBV
HEADPHONE
Connector : ø6mm TRS Phone jack
Load Impedance : 10 Ω ~ 50 Ω
Output Level : 20mW or more (at 16 Ω )
AUX SEND 1 and 2
Connector : ø6mm TRS Phone jack (Tip: SEND1, Ring: SEND2)
Load Impedance : 10k Ω or more
Cleaning the exterior
* For normal cleaning, use a soft dry cloth.
For stubborn dirt, moisten a cloth in diluted detergent, wring it out firmly, and wipe the dirt off.
Then polish with a dry cloth. Never use solvents such as alcohol, thinner or benzene, since these will
damage the printing and finish of the exterior.