Fostex VF-16 - Manual (Page 68)

68
flashing
flashing
3. Press the [ENTER/YES] key.
The tracks are instantly exchanged.
“Completed!” appears on the display when the tracks are
successfully exchanged. Then the LCD returns to the
original time base display.
When exchanging mono tracks.
1. Turn the [JOG] dial while “1-8” is flashing.
By turning the [JOG] dial to the left and right it is possible
to select the mono track numbers “1”, “2”, “3”, “4”...”24"
other than “01-08”. At the same time, the display on the
right also shows the mono track display.
If, for example, the [JOG] dial is turned to “4” for the left
track number, then “Track Exchange 4<->1” appears on
the display. This means track 4 and 1 can be exchanged.
2. To select a track number on the right, press the [HOLD/
>] key, [REWIND] key, or [F FWD] key to move the flashing
point (cursor). Use the [JOG] dial to choose the number
desired.
The numbers on the right and left of mono tracks
mean the same thing, therefore, the numbers can be
reversed and still mean the same thing.
In other words, “Track Exchange 4<->1” and “Track
Exchange 1<->4” mean the same thing. This
representation means that tracks 1 and 4 will be
exchanged, regardless of which number comes first.
Note that the same tracks on the left and right cannot
be exchanged on mono track units. Even if selected,
the operation will be invalidated and result in an
error message. If the same track is erroneously
specified and executed, a “Select Err” message
instantaneously appears on the LCD, and then
returns to the state prior to the error state.
3. Press the [ENTER/YES] key.
The tracks are instantly exchanged.
“Completed!” appears on the display when the tracks are
successfully exchanged. Then the LCD returns to the
original time base display.