Kenmore Elite 79575559400 Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for Elite 79575559400 Kenmore
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 35 |
| Size: | 532 KB |
Show table of contents
Document Outline
- TABLE OF CONTENTS
- BOTTOM FREEZER REFRIGERATOR
- WARRANTY—U.S.A.
- A WARNING
- SAVE THESE INSTRUCTIONS
- A WARNING
- A WARNING
- A WARNING
- A WARNING
- A WARNING
- Explosion Hazard
- HOWTO REMOVE DOOR/DRAWER HANDLES
- HOWTO REPLACE DOOR/DRAWER HANDLES
- REMOVING AND REPLACING REFRIGERATOR DOORS
- HOWTO REMOVE AND INSTALL THE PULLOUT DRAWER
- LEVELING AND DOOR ALIGNMENT
- ENSURING PROPER AIR CIRCULATION
- MULTI-FLOW
- SETTING THE CONTROLS
- ADJUSTING CONTROL SETTINGS
- FOOD STORAGE GUIDE
- STORING FROZEN FOOD
- REFRIGERATOR FEATURES
- FREEZER FEATURES
- TILTING DOOR
- ICE BIN
- TILT-OUT DOOR BASKET
- DURABASE DIVIDER
- DURABASE
- WATER FILTER
- GENERAL CLEANING TIPS
- OUTSIDE
- INSIDE WALLS (allow freezer to warm up so cloth won’t stick)
- DOOR LINERS AND GASKETS
- PLASTIC PARTS (covers and panels)
- CONDENSER COILS
- LIGHT BULB REPLACEMENT
- POWER INTERRUPTIONS
- WHEN YOU GO ON VACATION
- WHEN YOU MOVE
- A WARNING
- OPERATION INSTRUCTIONS
- A newly-installed refrigerator may take 12 to 24 hours to begin making ice.
- WHEN YOU SHOULD SET THE ICEMAKER POWER SWITCH TO O (OFF)
- NORMAL SOUNDS YOU MAY HEAR
- PREPARING FOR VACATION
- BEFORE YOU BEGIN
- WHAT YOU WILL NEED
- INSTALLATION INSTRUCTIONS
- INSTALLATION INSTRUCTIONS (CONTINUED)
- 4. FASTEN THE SHUTOFF VALVE
- 5. TIGHTEN THE PIPE CLAMP
- 7. CONNECT THE TUBING TO THE VALVE
- 8. FLUSH OUT THE TUBING
- 9. CONNECT THE TUBING TO THE REFRIGERATOR
- 10.TURN THE WATER ON AT THE SHUTOFF VALVE
- 11. PLUG IN THE REFRIGERATOR
- 12. START THE ICEMAKER
- UNDERSTANDING SOUNDS YOU MAY HEAR
- REFRIGERATOR DOES NOT OPERATE
- COMPRESSOR MOTOR SEEMS TO RUN TOO MUCH
- THERE IS WATER IN THE DEFROST DRAIN PAN
- THE REFRIGERATOR SEEMS TO MAKE TOO MUCH NOISE
- THE ICEMAKER IS NOT PRODUCING ICE OR ICE CUBES ARE FREEZING TOO SLOWLY
- CUBES PRODUCED BY ICEMAKER ARE TOO SMALL
- THE DOORS ARE DIFFICULT TO OPEN
- TEMPERATURE IS TOO WARM OR THERE IS INTERIOR MOISTURE BUILDUP