Kenmore Elite 79575559400 User Manual
Kenmore elite refrigerator
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Table of contents
Document Outline
- TABLE OF CONTENTS
- BOTTOM FREEZER REFRIGERATOR
- WARRANTY—U.S.A.
- A WARNING
- SAVE THESE INSTRUCTIONS
- A WARNING
- A WARNING
- A WARNING
- A WARNING
- A WARNING
- Explosion Hazard
- HOWTO REMOVE DOOR/DRAWER HANDLES
- HOWTO REPLACE DOOR/DRAWER HANDLES
- REMOVING AND REPLACING REFRIGERATOR DOORS
- HOWTO REMOVE AND INSTALL THE PULLOUT DRAWER
- LEVELING AND DOOR ALIGNMENT
- ENSURING PROPER AIR CIRCULATION
- MULTI-FLOW
- SETTING THE CONTROLS
- ADJUSTING CONTROL SETTINGS
- FOOD STORAGE GUIDE
- STORING FROZEN FOOD
- REFRIGERATOR FEATURES
- FREEZER FEATURES
- TILTING DOOR
- ICE BIN
- TILT-OUT DOOR BASKET
- DURABASE DIVIDER
- DURABASE
- WATER FILTER
- GENERAL CLEANING TIPS
- OUTSIDE
- INSIDE WALLS (allow freezer to warm up so cloth won’t stick)
- DOOR LINERS AND GASKETS
- PLASTIC PARTS (covers and panels)
- CONDENSER COILS
- LIGHT BULB REPLACEMENT
- POWER INTERRUPTIONS
- WHEN YOU GO ON VACATION
- WHEN YOU MOVE
- A WARNING
- OPERATION INSTRUCTIONS
- A newly-installed refrigerator may take 12 to 24 hours to begin making ice.
- WHEN YOU SHOULD SET THE ICEMAKER POWER SWITCH TO O (OFF)
- NORMAL SOUNDS YOU MAY HEAR
- PREPARING FOR VACATION
- BEFORE YOU BEGIN
- WHAT YOU WILL NEED
- INSTALLATION INSTRUCTIONS
- INSTALLATION INSTRUCTIONS (CONTINUED)
- 4. FASTEN THE SHUTOFF VALVE
- 5. TIGHTEN THE PIPE CLAMP
- 7. CONNECT THE TUBING TO THE VALVE
- 8. FLUSH OUT THE TUBING
- 9. CONNECT THE TUBING TO THE REFRIGERATOR
- 10.TURN THE WATER ON AT THE SHUTOFF VALVE
- 11. PLUG IN THE REFRIGERATOR
- 12. START THE ICEMAKER
- UNDERSTANDING SOUNDS YOU MAY HEAR
- REFRIGERATOR DOES NOT OPERATE
- COMPRESSOR MOTOR SEEMS TO RUN TOO MUCH
- THERE IS WATER IN THE DEFROST DRAIN PAN
- THE REFRIGERATOR SEEMS TO MAKE TOO MUCH NOISE
- THE ICEMAKER IS NOT PRODUCING ICE OR ICE CUBES ARE FREEZING TOO SLOWLY
- CUBES PRODUCED BY ICEMAKER ARE TOO SMALL
- THE DOORS ARE DIFFICULT TO OPEN
- TEMPERATURE IS TOO WARM OR THERE IS INTERIOR MOISTURE BUILDUP