Heat & Glo Fireplace 8000CL-IPI-S - Manual (Page 61)

61
Heat & Glo • 6000CL-IPI-S, 6000CL-IPI-T, 8000CL-IPI-S 8000CL-IPI-T • 2165-900 Rev. S • 9/12
H. Install the Log Assembly Log Assembly: LOGS-6CL
Models: 6000CL-IPI-S, 6000CL-IPILP-S,
6000CL-IPI-T, 6000CL-IPILP-T
CAUTION: Logs are fragile, handle with care. Log #1 (SRV2164-701): Locate log placement tabs on the pilot cover. Bend
tabs upward as shown in Figure 2. Locate the log placements slots on the bottom of Log # 1 (see Figure 3). Mate the slots
located on the bottom of Log #1 with the log placement tabs on the pilot cover. Log # 1 is properly installed when it sits
squarely and completely on pilot cover with tabs engaged (see Figure 4).
Figure 3
Figure 1
LOG PLACEMENT TABS
Figure 2
LOG PLACEMENT SLOTS
LOG PLACEMENT TABS
Figure 4
Log #2 (SRV2164-702): Mate the slot located on the bottom of Log #2 with the left log placement tab on top of Log #1.
After slot and tab have been fitted together, mate the groove located on the bottom of Log #2 with the horizontal grate bar
and slide Log # 2 toward the left until it rests against the far left grate tine.
GROOVES
SLOTS
Figure 4 shows the log placement tabs located on the top of Log # 1. The tabs will be mated with the slots located on the
bottom of Log #2 and Log #3 (see Figure 5). Log #2 and Log #3 also have grooves that allow the logs to be seated properly
on the grate (see Figure 5). Hold Log #1 upright while placing Log #2.
Figure 5 Figure 6
1
2
1
LEFT GRATE TINE
LOG PLACEMENT INDENTATIONS
GRATE TINE
3
2
Bottom views of
Logs # 2 and 3
GUIDE SLEEVES
FIBER BURNER TOP
TAB BENT IN = NG
TAB NOT BENT = LP
BURNER ASSEMBLY
PILOT COVER
LOCATING HOLES
BURNER SHIELD