Installing a cablecard, See “installing a cablecard” on – HP md5020n User Manual
Page 30
Setting Up the TV
30
4.
Insert the CableCARD module
1
into the opening and firmly press it into place until the front plate is
flush with the panel.
5.
Tighten the two screws
2
.
Installing a CableCARD
You must obtain the CableCARD from your local cable provider. After installing the card, follow any setup
instructions provided with the card.
1.
Hold the CableCARD with the front label facing up, and then insert it into the CableCARD slot.
2.
Gently push the card into the slot until it stops. When fully inserted, the card sticks out of the slot.
3.
Press Settings, go to Setup > Channel setup > Cable card, and press OK. Your cable provider uses the
information in the CableCARD screens to activate and configure the CableCARD.
To remove the CableCARD, pull the card out of the slot. The CableCARD functions are automatically
removed.