HP md5020n - Manual (Page 20)

Setting Up the TV 20
Cable with Set-Top Cable Box
If your cable service requires a set-top cable box (STB) to view scrambled channels, connect the components
to the TV as shown in the following illustration. This setup enables you to watch scrambled and unscrambled
channels.
NOTE:
• If your cable box has different connectors from those shown, use the highest quality video
connection available. Observe the color-coding on connectors.
• For digital cable, your set-top cable box might require a special two-direction splitter. Contact
your cable provider for information. Or you can omit the splitter and omit the connection to the
TV cable input.
• If all cable channels are scrambled, connect the incoming cable directly to the cable box (omit
the splitter and omit the connection to the TV cable input).
• You can eliminate the cable box if your cable provider can install a CableCARD in the TV. See
“Installing a CableCARD” on page 30.
To do this... Do this...
Watch cable-box channels Press Source and select Component 1.
Watch cable channels directly Press Source and select Cable.
Program the remote control to operate the cable box See “Programming for Other Devices” on page 36.
Use the remote control to operate the cable box Press Device to select STB.
Connect additional equipment See “Planning for Other Equipment” on page 11.