Humax HDCI-2000 - Manual (Page 62)

• Go to Stored Position
Move the antenna to the position of the selected satellite.
1. Select Go to Stored Position using the button and press the OK button.
2. Wait till the antenna moves to the position of the satellite.
3. Confirm signal strength and quality level and fine-tune the antenna direction. Select Go to Stored Position
using the button. Move the antenna East/West by pressing the button. Adjust Signal Level to
maximum.
**
• Store Current Position
Save the adjusted position of the satellite.
1. Select Store Current Position using the button and press the OK button.
2. The position of the antenna headed for the certain satellite will be saved.
Note: You can set the antenna position by repeating the procedure above.
**
• Recalculate
You can recalculate the position of all satellites based on one satellite. Adjust the antenna position of a certain
satellite.
1. Select Recalculate using the button and press the OK button.
2. To readjust all positions, select Yes and press the OK button.
Note: When Motor Type is set as USALS, Motor Driving, Store Current Position, Recalculate is set to
Disabled.
GB 61