Humax HDCI-2000 - Manual (Page 58)

2. Motor Antenna
When using a motor antenna, set the antenna to Motor before performing channel search.
1. Press the OPT+ button to switch to motor antenna in
Antenna Setting mode.
2. A pop-up message will appear. Select Yes and press the OK
button.
**
Motor Type
You should set the motor type before motor antenna setting.
• LNB Frequency
1. Select LNB Frequency using the button.
2. Select one option among Universal, 9750, 10600, 5150,
11475 and User Define using the OK or button. If
the required value does not exist, select User Define and
enter the LNB frequency directly.
**
• LNB Voltage
1. Select LNB Voltage using the button.
2. Select one option from Standard and High using the OK
or button.
Note: When LNB Voltage is set as High, a pop-up appears.
"Only for LNB cable over 30m, Set LNB power High."
**
GB 57