Humax HDCI-2000 - Manual (Page 76)

1. New software is found when powering on
1. A message will pop up to notify that a new software is found.
2. Select Immediate and press the OK button to start updating immediately. Select Later and press the OK
button to update later(stand-by). Select Refuse and press the OK button to return to the previous menu
without updating.
3. Software download starts. Please wait until the update is completed.
4. When software update is complete, the equipment is automatically powered off and on again.
**
Note: You can delay the software update up to 10 times when you select Refuse.
2. Mandatory Update
1. A message will pop up to notify updating.
2. Press the OK button to start updating immediately.
**
Note: You cannot operate any buttons except for the OK button.
GB 75