Humax HDCI-2000 - Manual (Page 57)

Satellite
1. Select Satellite using the button.
2. Select the satellite the antenna is pointing to from the options
using the OK or button.
3. If the required satellite is not available in the list, select User
Define. When pop up appears, select Yes and press the OK
button to view keyboard. Enter the name of the satellite and
select Save. Press the OK
button to complete.
**
LNB Frequency
1. Select LNB Frequency using the button.
2. Select one option among Universal, 9750, 10600, 5150, 11475 and User Define using the OK or
button.
If the required value does not exist, select User Define and enter the LNB frequency directly.
**
Note: If you select Universal, the 22KHz Tone value is set to Disabled.
**
22KHz Tone
1. Select 22KHz Tone using the button.
2. Select Enable/Disable using the OK or button.
Enable Dual LNB is used or two antennas are connected to the 22KHz tone switch box.
Disable 22KHz is not in use.
**
DiSEqC Input
1. Select DiSEqC Input using the button.
2. Select one option among Disable, DiSEqC A~D and Tone Burst A, B using the OK or button.
**
LNB Voltage
1. Select LNB Voltage using the button.
2. Select one option from Standard and High using the OK or button.
**
Note: When LNB Voltage is set as High, a pop-up appears. "Only for LNB cable over 60m, Set LNB power High."
10. Installation
GB 56