HP DL185 - Manual (Page 92)

Contents 92
• Administrator Password --- Display if an administrator password is Set or Not.
• Change Administrator Password --- Allows you to access and change all settings in the Setup
Utility. The administrator password allows you to configure access for system users.
To set a new administrator password:
1. In the Security screen, select a set password field - Change Administrator Password, and then
press Enter.
2. Type a new password in the Enter New Password box.
3. The password may consist of up to six characters. Alphanumeric characters (A-Z, a-z, 0-9) are
recommended to avoid system error.
4. Retype the password to verify the first entry, and then press Enter.
5. Press F10 to close the Setup Utility.
6. After setting the password, Setup automatically sets the password check to Setup.
Figure 8 Security menu of the BIOS Setup Utility 3
When administer password is installed, use this menu to check password:
• Setup --- Check password while invoking setup.
• Always --- Check password while invoking setup as well as on each boot.