HP 2500C Series - Manual (Page 89)

Operating Overview 2-31
631 FLASH_ERR_ERASE_CMD Error can only occur when flashing firmware Flash chip failure.
632 FLASH_ERR_ERASE_FAILED Error can only occur when flashing firmware
633 FLASH_ERR_TIME_ES_INIT Error can only occur when flashing firmware
634 FLASH_ERR_TIME_SUSPEND Error can only occur when flashing firmware
635 FLASH_ERR_TIME_PAGEBUF Error can only occur when flashing firmware
636 FLASH_ERR_TIME_QUEUE Error can only occur when flashing firmware
637 FLASH_ERR_TIME_CMD Error can only occur when flashing firmware
38 FLASH_ERR_VPP_BAD Error can only occur when flashing firmware
641 FLASH_ERR_WRITE_START Error can only occur when flashing firmware
642 FLASH_ERR_WRITE_FAILED Error can only occur when flashing firmware
643 FLASH_ERR_DATA_BAD Error can only occur when flashing firmware Read-after-write failed.
651 FLASH_ERR_2MANY_ERASE Error can only occur when flashing firmware Excessive erase attempts.
661 FLASH_ERR_2MANY_WRITE Error can only occur when flashing firmware Excessive write attempts.
671 FLASH_ERR_BUF_DATA_BAD Error can only occur when flashing firmware Chip's page buffer write failed.
672 FLASH_ERR_ENCODING Error can only occur when flashing firmware Block's encoding method unknown.
Personality (cont'd)
711 RED_DM_PML_ERROR PCA problem can also be caused by MIO card PML subsystem (general).
712 RED_DM_PML_OPEN_SOCKET_ERROR PCA problem can also be caused by MIO card Could not open PML socket.
713 RED_DM_PML_IO_NOTIFY_ERROR PCA problem can also be caused by MIO card Could not set up callback.
714 RED_DM_PML_MEMPOOL_ERROR PCA problem can also be caused by MIO card Could not allocate PML pool.
715 RED_DM_PML_IO_READ_ERROR PCA problem can also be caused by MIO card Could not read from PML socket.
721 RED_DM_PM_INSUFFICIENT_MEM PCA problem can also be caused by MIO card PM could not get its structure.
Swath Manager
811 SM_PRINTING_OFF Firmware issue – reset printer Printing has been cancelled.
812 SM_NON_10X_ADVANCE Firmware issue - reset printer Non-x10 advance performed in a shingled mode.
813 SM_SWING_BUF_NON_ZERO All data received=0 – reset printer Used in AssertSwingBuffersAllZero().
820 SM_NO_MEMORY_FOR_LOG Not enough memory available – reset printer No memory for print logging.
User Interface
911 UI_MSG_Q_CREATE Not used Could not create the message queue.
912 UI_BUTTON_WD Not used Could not create button-reading watchdog.
913 UI_INDICATOR_WD Not used Could not create indicator-flashing watchdog.
914 UI_RESET_WD Not used Could not create reset button watchdog.
915 UI_UNKNOWN_IND_STATE Not used Unknown indicator state: state machine confused.
Device Manager
921 DEV_MGR_IDLE_INIT_ERR Reset printer Failed to start idle loop.
922 DEV_MGR_WD_START_ERR Reset printer Failed to create watchdog.
923 DM_MSGQ_CREATION_ERROR Reset printer Failed to create a message queue.
924 DM_UNSUPPORTED_MESSAGE Reset printer Received an unrecognized DM message.