HP 2500C Series - Manual (Page 160)

Removal and Replacement of Parts (without Calibration) 7-10
Replacement of Parts
Installing the Service Station
Step 1. Gently slide the new service station into the printer until the screw holes are aligned.
Step 2. Reconnect the service station connector. Ensure that it is properly plugged in.
Step 3. Replace the three screws at the top of the service station in order (that is, replace number one,
followed by two and then three).
Step 4. Put back the service station side cover.
Step 5. Replace the two screws for the service station side cover.
Step 6. Close the rear access door.
Step 7. Place the printhead access door by fitting the left tab under the top cover.
Step 8. Plug in the power cord and turn on the printer.
Note
To ensure that the alignment of the Service Station with the Printheads is correct, replace the Service
Station screws in the correct order when installing the Service Station.