Replacement of parts – HP 2500C Series User Manual

Page 199

Removal and Replacement of Parts (without Calibration) 7-47

Replacement of Parts

Installing the Absorber

Step 1. Replace the absorbers into position.

Step 2. Gently slide the new service station into the printer until the screw holes are aligned.

Step 3. Replace the service station connector. Ensure that it is properly plugged in.

Step 4. Replace the three screws at the top of the service station in order (that is, replace number one,

followed by two and then three).

Step 5. Replace the remaining components for the Ink Supply Station (refer to the procedures in Installing

the Ink Supply Station from Replacement of Ink Supply Station).