Replacement of parts – HP 2500C Series User Manual

Page 173

Removal and Replacement of Parts (without Calibration) 7-23

Replacement of Parts

Installing the MIDS

Step 1. Attach the retainer clip to the tubes and to fasten them in place to the chassis with the screw.

Step 2. Fasten the screw between “C” and “M”.

Step 3. Replace the pump section, tilting it an angle such that the catch next to the yellow nozzle is latched

first, and replace the screws.

Step 4. Replace the remaining components for the MIDS (refer to Steps 3-14 of Installing the Power Knob

from Replacement of Power Knob.)