Replacement of parts – HP 2500C Series User Manual

Page 171

Removal and Replacement of Parts (without Calibration) 7-21

Replacement of Parts

Installing the Power Supply

Step 1. Slide in the new power supply.

Step 2. Reconnect the power supply connector. Make sure the connector is secured properly.

Step 3. Reinstall the power supply cover. Make sure the ESD clip is on the outside of the cover and the

screw holes are aligned.

Step 4. Replace the five screws. Do not over-tighten the plastic screws (the two at the bottom of the cover).

Step 5. Replace the remaining components for the power supply (refer to Steps 3-14 of Installing the Power

Knob from Replacement of Power Knob.)