HP 2103R-CSDI - Manual (Page 33)

Configuring DIP Switches 2-9
Figure 2-2 shows the ONline carrier DIP switch location.
Figure 2-2 ONline Carrier DIP Switch Location
Selecting a Network
Use Table 2-4 to select a network by using the DIP switches.
Isolating the ONline Edge Router Module
To isolate the Edge Router module from all backplane networks, set the DIP
switches to the Isolated position as defined in Table 2-4.
Configuring the
ONcore Carrier DIP
Switches
ONcore carrier DIP switches allow you to set the following configuration
parameters:
Table 2-4 ONline Network Selection DIP Switch Settings
Network Selection
Switch Settings
Switch 1 Switch 2 Switch 3 Switch 4
Ethernet_1 (default) ON ON ON ON
Ethernet_2 ON OFF ON ON
Ethernet_3 OFF ON ON ON
Isolated OFF OFF ON ON
1234
ON