beautypg.com

Approvals and codes – Heat & Glo Fireplace 6000TR-OAK User Manual

Page 4

background image

Heat & Glo • 6000TR-OAK, 6000TR-OAK-IPI • 383-901 Rev. K • 5/06

8

Appliance Certification

The Heat & Glo fireplace models discussed in this Installers

Guide have been tested to certification standards and listed

by the applicable laboratories.

Certification

MODELS: 6000TR-OAK, 6000TR-OAK-IPI

LABORATORY: Underwriters Laboratories

TYPE: Direct Vent Gas Fireplace Heater

STANDARD: ANSI Z21.88-2000•CSA2.33-M98•UL307B

Installation Codes

The fireplace installation must conform to local codes. Before

installing the fireplace, consult the local building code

agency to ensure that you are in compliance with all

applicable codes, including permits and inspections.
In the absence of local codes, the fireplace installation must

conform to the National Fuel Gas Code ANSI Z223.1 (in

the United States) or the CAN/CGA-B149 Installation Codes

(in Canada). The appliance must be electrically grounded

in accordance with local codes or, in the absence of local

codes with the National Electric Code ANSI/NFPA No. 70

(in the United States), or to the CSA C22.1 Canadian Electric

Code (in Canada).
These models may be installed in a bedroom or bed-sitting

room in the U.S.A. and Canada.

1

Approvals and

Codes

High Altitude Installations

U.L. Listed gas appliances are tested and approved with-

out requiring changes for elevations from 0 to 2,000 feet in

the U. S. A. and in Canada.

When installing this appliance at an elevation above 2,000

feet, it may be necessary to decrease the input rating by

changing the existing burner orifice to a smaller size. Input

rate should be reduced by 4% for each 1000 feet above a

2000 foot elevation in the U.S.A. or 10% for elevations

between 2000 and 4500 feet in Canada. If the heating value

of the gas has been reduced, these rules do not apply. To

identify the proper orifice size, check with the local gas

utility.

If installing this appliance at an elevation above 4,500 feet

(in Canada), check with local authorities.

Heat & Glo Quality Systems

registered by SGS ICS

This manual is related to the following products: