HP 7600 User Manual
Page 16
hp photosmart 7600 series
chapter 1
12
Caution! Check that you are using the correct print cartridges. Also, note
that HP does not recommend modifying or refilling HP print cartridges.
Damage that results from modifying or refilling HP print cartridges is not
covered by HP’s warranty.
install or replace print cartridges
To get the best performance from your printer, use only genuine HP factory-filled
print cartridges.
To get maximum use from your print cartridges, turn off the printer when it is not
in use. Do not unplug the printer or turn off the power source (such as a power
strip) until the On/Attention light is off. Properly turning off the printer allows it
to store the print cartridges properly.
To install or replace the print cartridges:
1
If the printer is off, press the O
N
button on the printer’s control panel.
2
Load plain paper in the In tray so the printer can print a calibration page
after you install the print cartridges.
3
Lift the top cover of the printer.
4
Push down on the print cartridge latch and pull it forward. The print
cartridge latch pops open.
5
If you are replacing a print cartridge, slide out the old print cartridge and
store, recycle, or discard it.