Henny Penny 600 EN User Manual
Page 29
Model 500/561/600
3-14. CHANGING THE
CHARCOAL FILTER
(Continued)
8. Remove and discard old filter pad. Clean and dry pan, frame,
and grid thoroughly.
9. Place grid, frame and new charcoal filter pad in assembly with
smooth side facing the grid and secure with clips.
10. Slide the drain pan back into place under the fryer and connect
the filter union by hand. Do not use a wrench to tighten.
11. Slide the condensation drain pan back into place. The fryer is
now ready to operate.
3-15. CLEANING
THE FRYPOT
After the initial installation of the fryer, as well as before every change
of shortening, the frypot should be thoroughly cleaned as follows:
1. Turn the main power switch to OFF, and unplug unit from the
wall receptacle.
Moving either the frypot, or filter pan, while containing hot
shortening is not recommended. Hot shortening can splash
out. Severe burns could result.
The filter drain pan must be as far back under the fryer as it
will go, and the cover in place. Be sure the hole in the cover
lines up with the drain before opening the drain. Failure to
follow these instructions causes splashing of shortening and
could result in personal injury.
Step 9
703
3-29