HP dc5700 User Manual

Page 105

Service Reference Guide, dc5700

437804-001

7–1

Removal and Replacement Procedures—

Small Form Factor (SFF) Chassis

Adherence to the procedures and precautions described in this chapter is essential for proper
service. After completing all necessary removal and replacement procedures, run the Diagnostics
utility to verify that all components operate properly.

✎

Not all features listed in this guide are available on all computers.

7.1 Preparation

for

Disassembly

See

Chapter 5, “Identifying the Chassis, Routine Care, and Disassembly Preparation,”

for initial

safety procedures.

1. Close any open software applications.

2. Exit the operating system.

3. Remove/disengage any security devices that prohibit opening the computer.

4. Remove any diskette or compact disc from the computer.

5. Turn off the computer and any peripheral devices that are connected to it.

CAUTION: Turn off the computer before disconnecting any cables.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as

the system is plugged into an active AC outlet. In some systems the cooling fan is on even when the

computer is in the “Standby,” or “Suspend” modes. The power cord should always be disconnected

before servicing a unit.

6. Disconnect the power cord from the electrical outlet and then from the computer.

7. Disconnect all peripheral device cables from the computer.

✎

During disassembly, label each cable as you remove it, noting its position and routing.

CAUTION: The screws used in the computer are of different thread sizes and lengths; using the wrong

screw in an application may damage the unit.