HP 3300mfp - Manual (Page 31)

EN Installing and loading the media input trays 29
Installing and loading the media input trays
To install and load the media input tray and the priority input tray, use
the following steps:
1 Slide the trays in and down at an angle until they fit securely.
Remove the tape connecting the two trays.
2 Remove the priority input tray.
3 Push in the guides past the normal paper size mark.
4 Roll the paper and place it in the tray.
5 Push down on the paper so it lies flat in the tray.
6 Push in the bottom guide so it is snug.
7 Install the priority input tray over the media input tray.
Note
If the media guides are not sufficiently tight, your media may skew and
cause a media jam.
1
3
4
5
6