Honeywell ST 3000 - Manual (Page 35)

4.1 Mounting ST 3000 Transmitter,
Continued
Bracket mounting,
continued Table 8 Mounting ST 3000 Transmitter to a Bracket, continued
Step Action
3 Align appropriate mounting holes in transmitter with holes in bracket
and secure with bolts and washers provided.
If transmitter is … Then …
DP type with double-ended use alternate mounting
process heads and/or holes in end of heads.
remote seals
GP and AP with single- use mounting holes in side
ended head of meter body.
In-line GP use smaller “U” bolt
(LGP model) provided to attach meter
body to bracket.
See figure below.
Dual head GP and AP use mounting holes in end
of process head.
Example – LGP model transmitter mounted to optional angle
mounting bracket.
LGP Models
Meter Body
Smaller
“U” bolt
Use bracket for
hexagonal meter body
NOTE: If the meter body is hexagonal, you must use the additional
bracket supplied. If meter body is round, discard the
bracket.
Continued on next page
2/05 ST 3000 Release 300 Installation Guide 25