Honeywell ST 3000 - Manual (Page 34)

4.1 Mounting ST 3000 Transmitter,
Continued
Dimensions Detailed dimension drawings for given transmitter series and types are
listed in Section 5 for reference. Note that abbreviated overall
dimensions are also shown in the specification sheets for the given
transmitter models.
This section assumes that the mounting dimensions have already been
taken into account and the mounting area can accommodate the
transmitter.
Bracket mounting Table 8 summarizes typical steps for mounting a transmitter to a
bracket.
Table 8 Mounting ST 3000 Transmitter to a Bracket
Step Action
1
If you are using an… Then…
optional mounting bracket go to Step 2.
existing mounting bracket go to Step 3.
2 Position bracket on 2-inch (50.8 mm) or, and install “U” bolt around
pipe and through holes in bracket. Secure with nuts and lockwashers
provided.
Example - Angle mounting bracket secured to horizontal or vertical
pipe.
Horizontal Pipe
Mounting
Bracket
Nuts and
Lockwashers Nuts and
Lockwashers
U-Bolt
U-Bolt
Mounting
Bracket
Vertical Pipe
Continued on next page
24 ST 3000 Release 300 Installation Guide 2/05