HP 630 series - Manual (Page 86)

86 hp photosmart 630 series user’s manual
Resetting the camera
If your camera does not respond when you press any buttons,
use the Reset switch to reset the camera:
1 Open the battery/memory card
door on the bottom of the
camera. The Reset switch is the
inset square located behind the
memory card slot, as shown.
2 Press the straightened end of a
paper clip into the Reset switch
until the switch is depressed,
then remove the paper clip. The
camera is reset.
3 Close the battery/memory card door. You may now use the
camera again.