HP 630 series - Manual (Page 15)

Chapter 1: Getting started 15
Attaching the lens cap
1 Pinch the grips on the sides of the
lens cap with your thumb and
finger as shown.
2 Fit the lens cap into the lens ring
on the front of the camera and
release the grips on the lens cap.
Make sure the lens cap snaps
into place.
To remove the lens cap, pinch the grips on the sides of the lens
cap with your thumb and finger, and pull the lens cap off the
lens ring.
Installing the batteries
1 Open the battery/memory
card door on the bottom of
the camera.
2 Insert the batteries as indicated
inside the door.
3 If you do not have an optional
memory card to install in the
camera, close the battery/
memory card door and skip to Turning on power on
page 17. If you want to install an optional memory card,
leave the battery/memory card door open and proceed to
the next section, Installing a memory card (optional) .
NOTE For more information, see Managing batteries on
page 106. You can also use an optional HP AC power
adapter to power the camera, and you can recharge
batteries in the camera using an optional HP AC power
adapter or HP 8886 camera dock. For more information,
see Purchasing camera accessories on page 110.