Hitachi SJ200 Series - Manual (Page 205)

SJ200 Inverter
T
roub
leshooting
and Maintenance
6–15
IGBT Test Method
The following procedure will check the inverter transistors (IGBTs) and diodes:
1. Disconnect input power to terminals [R, S, and T] and motor terminals [U, V, and W].
2. Disconnect any wires from terminals [+] and [RB] for regenerative braking.
3. Use a Digital Volt Meter (DVM) and set it for 1
Ω resistance range. You can check the
status of the charging state of terminals [R, S, T, U, V, W, RB, +, and –] of the inverter
and the probe of the DVM by measuring the charging state.
Table Legend – Almost infinite resistance:
≅ ∞ Ω Almost zero resistance: ≅ 0 Ω
NOTE: The resistance values for the diodes or the transistors will not be exactly the
same, but they will be close. If you find a significance difference, a problem may exist.
NOTE: Before measuring the voltage between [+] and [–] with the DC current range,
confirm that the smoothing capacitor is discharged fully, then execute the tests.
Part
DVM
Measured
Value
Part
DVM
Measured
Value
Part
DVM
Measured
Value
+ – + – + –
D1 [R] +1
≅ ∞ Ω
D5 [S] [N]
≅ 0 Ω
TR4 [U] [–]
≅ 0 Ω
+1 [R]
≅ 0 Ω
[N] [S]
≅ ∞ Ω
[–] [U]
≅ ∞ Ω
D2 [S] +1
≅ ∞ Ω
D6 [T] [N]
≅ 0 Ω
TR5 [V] [–]
≅ 0 Ω
+1 [S]
≅ 0 Ω
[N] [T]
≅ ∞ Ω
[–] [V]
≅ ∞ Ω
D3 [T] +1
≅ ∞ Ω
TR1 [U] [+]
≅ ∞ Ω
TR6 [W] [–]
≅ 0 Ω
+1 [T]
≅ 0 Ω
[+] [U]
≅ 0 Ω
[–] [W]
≅ ∞ Ω
D4 [R] [N]
≅ 0 Ω
TR2 [V] [+]
≅ ∞ Ω
TR7 [RB] [+]
≅ 0 Ω
[N] [R]
≅ ∞ Ω
[+] [V]
≅ 0 Ω
[+] [RB]
≅ ∞ Ω
TR3 [W] [+]
≅ ∞ Ω
[RB] [–]
≅ 0 Ω
[+] [W]
≅ 0 Ω
[–] [RB]
≅ 0 Ω
[R]
[S]
[T]
TR1 TR2 TR3
[U]
[V]
[W]
[–]
D1 D2 D3
D4 D5 D6
+
[+] [RB] [+1]
TR4 TR5 TR6 TR7