Epson Multi-mode Data Controller MFJ-1278B - Manual (Page 368)

MFJ-1278B MULTI-MODE APPENDIX H COMMAND SUMMARY
Command Paramete
r Default Mode Function Page
RETries nnn I-command Pactor Specifies number of error packet cycles. 6-104
RETRY n 10 Packet Allows retransmission of frames that are
not acknowledged. 6-104
REVFLIM call-n blank M-Packet Callsigns of BBS to enable reverse-
forwards. 6-105
RFE ON|OFF off AMTOR Will continue to retry until a QRT is
received. 6-105
RINV ON|OFF off AMTOR Controls the incoming received signal to
be inverted before detection/processing
occurs. 6-105
RXBLOCK ON|OFF off Packet Determines whether the information will
be sent in standard or block format. 6-106
RXBRIGHT n 4 SSTV/FAX Determines brightness and contrast of
SSTV or FAX pictures 6-107
RXCAL -- I-command All Generates test signals that are used by the
internal tuning software to align the
demodulator circuit. 6-108
RVFALWAY ON|OFF on M-Packet Initiates forwards and reverse of all
forwardable messages. 6-110
RXINVERT ON|OFF off RTTY/ASCII Inverts the mark and space tones. 6-110
SCREENLN n 0 All Used to properly format terminal output. 6-110
SELCALL ssss I-command AMTOR Initiate a mode L "SELCALL" broadcast. 6-111
SENDPAC n $0D (CR) Packet Selects the character that will force a
packet to be sent in CONVERSE mode. 6-111
SERIALNO 0-65535 0 CW Used for contest serial numbering. 6-111
SETUP n I-command All Used to set the mode and baud rate.
Similar to the MODE command. 6-112
SFNL ON|OFF on AMTOR Controls whether the 1278B adds a new
line character to "+?" and WRU. 6-112
SLOTS nn 3 Packet Determines how many sides are on the
slot time dice. 6-113
SOLF ON|OFF on AMTOR Determines whether only characters
from the AMTOR receiver are sensed as
newline characters. 6-113
SRXALL ON|OFF on AMTOR Causes the MFJ-1278B to print all
receivable mode S transmissions. 6-114
START n $11 (^Q) All Selects the user restart character. 6-114
STatus -- I-command Pactor Displays debug information helpful in
troubleshooting Pactor problems. 6-114
STATUS -- I-command AMTOR Returns useful diagnostic information for
helping us help you with your problems. 6-115
STOP n $13 (^S) All Selects the user stop character. 6-115
STREAMCA ON|OFF off Packet Used to enable the display of the
connected to station after the stream
identifier. 6-116
STREAMDB ON|OFF off Packet Used to display received
STREAMSWITCH characters by 6-117