Epson Multi-mode Data Controller MFJ-1278B - Manual (Page 366)

MFJ-1278B MULTI-MODE APPENDIX H COMMAND SUMMARY
Command Paramete
r Default Mode Function Page
MRPT ON|OFF on Packet Affects the way monitored packets are
displayed. 6-80
MSPEED nn 20 CW Sets the operational speed which the MFJ-
1278B will use for CW. 6-80
MSTAMP ON|OFF off Packet Enables the time stamping of monitored
packets. 6-81
MTIMEOUT 0-250 30 M-Packet Mailbox connect will timeout after a time
set by this command. 6-81
MULTIFAX ON|OFF off FAX Enables multi-level FAX transmitting and
receiving. 6-82
MYCALL call nocall Packet Sets the callsign of the MFJ-1278B. 6-82
MYcall callsign MFJPACTR Pactor Your Pactor amateur callsign 6-83
MYALIAS call-n blank Packet Specifies an alternate callsign for use as a
digipeater only. 6-83
MYDLCNUM 0-254 0 Host Sets the DLC number for Host Mode. 6-83
MYHIERAD nnnn text M-Packet Sets the heiarcal address text sent by a
Mailbox forward. 6-84
MYMCALL call nocall M-Packet Dedicated mailbox callsign. 6-84
MYSELCAL ssss blank AMTOR Tells the MFJ-1278B what SELCALL
your station should respond to. 6-84
NAVTEX -- I-command NAVTEX Allows you to receive NAVTEX signals. 6-85
NAVSTN xxxxx all NAVTEX Allows you to receive certain NAVTEX
stations. 6-85
NAVMSG x all NAVTEX Allows you to receive certain NAVTEX
messages. 6-86
NEWMODE ON|OFF off Packet Selects the way the MFJ-1278B behaves
when connections are made and broken. 6-87
NO200 ON/OFF OFF Pactor Enables or inhibits 200 baud Pactor mode. 6-88
NODEFORW -- I-command M-Packet Similar to Forward command but with
callsign+ up to 8 vias. 6-88
NODEPATH -- I-command M-Packet Commands connected node by Nodeflow
to link with the receiving BBS. 6-89
NOMODE ON|OFF off Packet Determines if the MFJ-1278B will switch
manually or automatically to command
mode. 6-89
NUCR ON|OFF off Packet Causes transmission of characters,
producing a delay following any sent
to the terminal. 6-90
NULF ON|OFF off Packet Same as NUCR, instead of it sends
a delay after a . 6-90
NULLS n 0 Packet Used in conjunction with NUCR and
NULF, and specifies how many
characters are sent. 6-90
OK -- I-command ASA Use with ASA command to accept the
analyzed signal. 6-91
OMLC ON|OFF off AMTOR Instructs the MFJ-1278B to convert all
characters, except those echoed, to their 6-91