Epson Multi-mode Data Controller MFJ-1278B - Manual (Page 183)

MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS
AUTOLF ON/OFF Mode: Packet Default: ON
Parameters:
ON
A linefeed character () is sent to the terminal after each carriage return
character ().
OFF
A is not sent to the terminal after each .
AUTOLF controls the display of carriage return characters received in packets as well as
echoing those that are typed in.
If the MFJ-1278B's sign-on message lines appear to be typed over each other, you should set
AUTOLF ON. If the MFJ-1278B's sign-on message appears that it is double-spaced, then
you should set AUTOLF OFF. If the MFJ-1278B's sign-on message appears to be single-
spaced, you have AUTOLF set correctly.
This command only affects what is displayed, not the data sent in packets. If you want to add
linefeed characters to outgoing packets, use the command LFADD.
AUtolf ON/OFF
Mode: Pactor Default: ON
Parameters:
ON
A linefeed character () is sent to the terminal after each carriage return
character ().
OFF
A is not sent to the terminal after each .
The AUTOLF command controls the display of carriage return characters received during
PACTOR monitoring, as well as echoing those that are typed in. For further information on
this command please refer to the AUTOLF command in Chapter 6 in the MFJ Data
Controller main instruction manual.