Epson Multi-mode Data Controller MFJ-1278B User Manual
Page 295
MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS
XOff nn
Mode: Pactor Default: ^S
Parameters:
nn = 0 <= nn <= 25
This command determines the Flow Control STOP character. The Pactor XOFF command
is the same as the XOFF command in the standard MFJ-1278B command set. For further
information on the XOFF command please refer to the explanation of the XOFF command
in Chapter 6 of the MFJ Data Controller Main Instruction Manual.
XOn nn
Mode: Pactor Default: ^Q
Parameters:
nn = 0 <= nn <= 255
This command determines the Flow Control START character. The Pactor XON command
is the same as the XON command in the standard MFJ-1278B command set. For further
information on the Pactor XON command please refer the explanation of the XON command
in Chapter 6 of the MFJ Data Controller Main Instruction Manual.
* see discussion above for more on XON/XOFF software flow control
XON n
Mode: All Default: $11
Parameters:
n 0 to $7F, specifying an ASCII character code.
This command selects the MFJ-1278B Restart character, which is sent by the MFJ-1278B to
the computer or terminal to restart input from that device. You can enter the code in either
hex or decimal.
This character would ordinarily be set to
operating your station in Converse Mode, and there is some chance that you might fill up the
MFJ-1278B's buffers, you might set this character to
many terminals.