Ericsson RX8000 Series - Manual (Page 83)

Chapter 3
To edit the Source IP Address 1:
1. Press the Edit key. The cursor appears below the first character of the displayed
value.
2. Edit the parameter value as required using the W (Back) and X (Forward) keys
to select each digit in turn, and then using the S (Up) and T (Down) keys to
increment or decrement the digit.
3. Press Save to save the new settings or Edit to abandon the operation and
return to the current setting.
3.5.3.2.6.3 2.2.6.3 UDP Port 1
To view and edit the UDP Port 1, press the T (Down) key. The following screen is
displayed:
STREAM 1 |UDP PORT 1
2.2.6.3 |04000
To edit the UDP Port 1 value:
1. Press the Edit key. The cursor appears below the first character of the displayed
value.
2. Edit the parameter value as required using the W (Back) and X (Forward) keys
to select each digit in turn, and then using the S (Up) and T (Down) keys to
increment or decrement the digit.
3. Press Save to save the new settings or Edit to abandon the operation and
return to the current setting.
3.5.3.2.6.4 2.2.6.4 Column Port 1
To view and edit the Column Port 1, press the T (Down) key. The following screen
is displayed:
STREAM 1 |COLUMN PORT 1
2.2.6.4 |00000
To edit the Column Port 1 value:
1. Press the Edit key. The cursor appears below the first character of the displayed
value.
2. Edit the parameter value as required using the W (Back) and X (Forward) keys
to select each digit in turn, and then using the S (Up) and T (Down) keys to
increment or decrement the digit.
3. Press Save to save the new settings or Edit to abandon the operation and
return to the current setting.
EN/LZT 790 0005 R1A 3-35