Ericsson RX8000 Series - Manual (Page 39)

Chapter 2
Warnings!
The RX8000 series receivers should only be operated from the type of power source
indicated on the marking label. If you are not sure of the type to your business,
consult your appliance dealer or local power company. Do not overload wall outlets
and extension cords as this can result in a risk of fire or electric shock.
The RX8000 series receivers are NOT fitted with an AC power ON/OFF switch.
Ensure the supply socket outlet is installed or located near the equipment so that it
is accessible.
Figure 2.2 AC Power Inlet Assembly
Note: See Annex B, Technical Specification for fuse information.
Supply Mains Inlet
Fuse Carrier
2.5.2 AC Power Supply Cord
2.5.2.1 General
A two-meter mains supply cord is supplied with this product. It is fitted with a molded
plug suitable for the USA, UK or mainland Europe as advised at the time of ordering.
Note: The equipment is not fitted with an AC power supply ON/OFF switch.
Ensure the socket-outlet supplying the equipment is installed near the
equipment so that it is easily accessible.
2.5.2.2 Wire Colors
The wires in the supply cord are colored as shown in Table 2.1.
EN/LZT 790 0005 R1A 2-7