Ericsson RX8000 Series - Manual (Page 133)

Chapter 5
There are also four Configuration buttons which allow the viewing and setting of
the tuning parameters for the four possible RF inputs.
Any changes which are made to the Satellite Input page may be confirmed by
selecting the Apply Changes button. Selecting the Refresh button will ensure that
the latest information is being displayed from the current values of the equipment.
5.2.6.2 Input > SAT Input > Configuration RF # 1-4
To view the Configuration settings for the chosen input, select the appropriate
Configuration button.
Figure 5.18 Configuration RF#1 Web Page
The following user-editable fields are displayed on this page:
• LNB (Low-Noise Block Converter) LO (Local Oscillator) Frequency – allows
the input of a frequency in MHz, in steps of 1 kHz.
• Satellite Frequency – allows the input of a frequency in MHz, in steps of 1 kHz.
• Symbol Rate – allows the input of a value in MSym/s.
• Modulation – allows the selection of a modulation type from a drop-down menu.
Available modulation types are license-dependant.
• RollOff – allows the selection of a rolloff rate from a drop-down menu.
• Spectrum Sense – allows the selection of the spectrum sense from a drop-
down menu.
• Search Range – allows the input of a range in kHz.
• LNB Power Op – allows the user to enable/disable the LNB Power Op.
• LNB Power Level – allows the selection of the LNB Power Level from a drop-
down menu. This setting is applied only when the LNB Power Op field is set to
ENABLE.
EN/LZT 790 0005 R1A 5-17