Efficient Networks 107-0001-000 - Manual (Page 507)

SpeedStream ® Router family
Command Line Interface Guide
Chapter 20: QoS Commands
Efficient Networks
®
Page 20-11
qos set
Defines one or more parameters of a QoS policy. To view the current configuration of
a policy, use the
qos list command.
NOTE:
The QoS policy must exist (created with the qos append or qos insert commands) and
be disabled prior to configuration.
Mgmt Class
Network (R/W)
Input Format
qos set []
Parameters
Multiple parameters can be entered in the same command for a single QoS policy; the
sequence of parameters in not essential. The parameters are listed below.
-sa
a
off | [:end address>]
Specifies the source address or range of addresses. Off will disable source-address checking.
-da tion address> a off | [:]
Specifies the destination address or range of addresses. Off will disable destination-address
checking.
-p off |
b
tcp | udp
Specifies the protocol by protocol number or explicitly TCP or UDP. Entering off will dis-
able the protocol check.
-sp
c
off | [:]
Specifies the source port or range of ports by number or specific application. Off dis-
ables the port check.
-dp off | [:]
off | ftp | telnet | smtp | http | snmp |tftp | dns | login | rsh |
h323 | t120
Specifies the destination port or range of ports by number or specific application. Off
disables the port check.
-pr high | medium | normal | low
Specifies the priority, with normal the default value.
-ic off |