Efficient Networks 107-0001-000 - Manual (Page 184)

Chapter 5: Ethernet Interface Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 5-46 Efficient Networks
®
NOTE:
The password must be the same for every router in the Virtual Router, that is, for
every router in the LAN with the same VRID. For example, if a VRRP interface in
routers A, B, and C has the VRID 7, routers A, B, and C must all specify the same
password for VRID 7.
NOTE:
This command takes effect immediately, but you must save the change if it is to
persist after you restart the interface or reboot the router.
Mgmt Class
Network (R/W)
Input Format
eth vrrp set password []
Parameters
Example
This command example specifies the password “AbCdEfGh” for VRID 7 using default
port 0.
Response
Command prompt.
preempt Preempt immediately.
a,b
a
ASCII string, 1 - 8 characters.
b
The password is case sensitive.
Password.
c
c Integer, 1 - 255
Virtual router ID of the VRRP attribute record (integer, 1-255). The
attribute record was created by the command
eth vrrp add
d
d The default is 0; the parameter may be omitted if the router has only one port.
Physical Ethernet interface (port) number (0 or 1).
-> eth vrrp set password AbCdEfGh 7