Efficient Networks 107-0001-000 - Manual (Page 166)

Chapter 5: Ethernet Interface Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 5-28 Efficient Networks
®
Parameters
Example
Response
Command prompt.
eth ip options
Enables or disables an IP option for the specified Ethernet interface. The IP options
include:
• Options to transmit or receive RIP-1 and/or RIP/2 packets. (see “ RIP
Controls” on page 6-4 of the Technical Reference Guide.)
• Option to advertise this router as the default router.
• Option to enable forwarding of IP multicast traffic.
NOTE:
This command is not effective until after save and reboot commands have been
performed.
Mgmt Class
Network (R/W)
Input Format
eth ip options on | off []
a
a
Dotted-decimal notation
Ethernet IP address.
sk> a IP subnet mask.
b,c
b
This parameter may be omitted if the router has only one Ethernet interface.
If the router has two physical Ethernet interfaces (an Ethernet hub router), the port number (0 or 1) must
be specified.
c To specify a logical interface other than logical interface 0, specify both the port number and the logical
interface number (:, for example, 0:1).
Ethernet interface.
-> eth ip mgmt 10.0.0.1 255.255.255.0 0:1
-> save
-> reboot