Epson ActionLaser 1600 - Manual (Page 18)

Software Installation
This chapter describes how to install the EpsonScript driver
and utilities for both the Macintosh and PC environments. See
the procedure that applies to you.
Installing the Macintosh Driver
To install the EpsonScript drivers and screen fonts on your
Macintosh, you first need to run the EpsonScript Installer
program. Then select the EpsonScript driver in the Chooser.
Running the EpsonScript Installer program
The Installer utility for the Macintosh driver has both an easy
and a custom installation.
The easy installation installs all EpsonScript files and screen
fonts that are not already installed on your Macintosh.
Normally, you should use the easy installation since this
ensures that all necessary files are copied and that the
Macintosh environment is modified to give you the full benefit
of the EpsonScript option.
The custom installation installs only the files you specify. You
might want to use the custom installation if you are low on disk
space and want to install only those files that are absolutely
required. However, if you have enough disk space, it is
recommended that you use the easy installation.
To install EpsonScript on your Macintosh:
1. Turn on your Macintosh if it is not already on Exit any
Macintosh programs you are currently running.
2-2 Installing the Drivers and Utilities