Epson IWE3200-H - Manual (Page 14)

9
Fig. 4. Connecting Ethernet cables to IWE500-INJ.
5. Check the “ACTIVE” LED: if power is successfully fed into the IWE3200-H, the “ACTIVE”
LED will be on (Red light); otherwise, the “ACTIVE” LED will be off.
6. If the electricity current is over the normal condition (Io＞1.0 A), the “ACTIVE” LED will flash
(Red light).
NOTE:
IWE500-INJ is specially designed for IWE3200-H. The use of IWE500-INJ with other
Ethernet-ready devices that are not compliant to IEEE 802.3af may cause damage to the
devices.
2.2. Mounting the IWE3200-H on a Wall
The IWE3200-H is wall-mountable.
1. Stick the supplied sticker for wall-mounting.
2. Use a φ 6.5mm driller to drill a 25mm-deep hole at each of the cross marks.
3. Plug in a supplied plastic conical anchor in each hole.
4. Screw a supplied screw in each plastic conical anchor for a proper depth so that the IWE3200-H
can be hung on the screws.
5. Hang the IWE3200-H on the screws.
Fig. 5. Mounting the IWE3200-H on a wall.