Epson IWE3200-H - Manual (Page 13)

8
2. First-Time Installation and Configuration
2.1. Selecting a Power Supply Method
The IWE3200-H can be powered by either the supplied AC power adapter or the optional
IWE500-INJ
POE Power Injector. The IWE3200-H automatically selects the suitable power de-
pending on your decision.
To power the IWE3200-H by the supplied power adapter:
1. Plug the power adapter to an AC socket.
2. Plug the connector of the power adapter to the power jack of the IWE3200-H.
NOTE:
This product is intended to be power-supplied by a Listed Power Unit, marked “Class 2”
or “LPS” and output rated “12V DC, 1.25 A minimum” or equivalent statement.
To power the IWE3200-H by IWE500-INJ Power Injector:
1. Connect the power cord cable from power outlet to the IWE500-INJ power connector.
To Power Outlet
Fig. 2. Connecting the power cord cable to IWE500-INJ.
2. Check the “POWER” LED: if system is normal, the LED will be on (Green light); otherwise, the
“POWER” LED will be off.
3. Connect the Ethernet cable (RJ-45 Category 5) from Ethernet Hub/Switch to the “DATA IN”
port of IWE500-INJ Power Injector.
4. Connect another Ethernet cable (RJ-45 Category 5) from “POWER & DATA OUT” port of the
IWE500-INJ
Power Injector to the IWE3200-H. Please note the indication on the panel of
POE-enabled RJ45 port of IWE3200-H (LAN interface #4).
Fig. 3. POE enabled LAN Port Position.