Epson 400 User Manual

Page 112

Caution:
Once you remove an ink cartridge, it becomes unusable and
cannot be reinstalled even if ink remains.

1. Make sure the printer is on, then open the printer cover.

2. Hold down the

load/eject button for three seconds, the

print head moves to the replace position. The

power

light begins flashing.

3. Lift the appropriate ink cartridge clamp. Dispose of the

empty ink cartridge properly.

4. Remove the yellow tape seal from the new cartridge and

lower the cartridge into the cartridge holder.

5. Press the ink cartridge clamp down until it locks in place.

Caution:
Once you install the cartridges, do not open their clamps
again until you replace the ink cartridges. Otherwise, the
cartridges may become unusable.

6. Press the

load/eject button again. The printer moves the

print head back to its home position and charges ink in the
system.

Caution:
The

power light continues to flash while the printer

performs the ink charging operation. Never turn off the
printer while the

power light is flashing. Doing so can

result in incomplete charging of ink.

Note:
Even if you do not press the

load/eject button, the printer moves the

print head back to its home position about 60 seconds after you
replace the cartridge.

les

Hawaii2 Ref. Guide
Rev.b

A5 size

Chapter 6

06-02-97

DR, pass 0

Troubleshooting

6-29