Enterasys Networks 7S4280-19-SYS - Manual (Page 38)

Installing the Chassis into a Rack
3-4 Enterasys Matrix N1 Chassis Setup
Installing the Chassis Directly to the Rack
To install the Enterasys Matrix N1 Chassis, proceed as follows:
1. Lift the chassis into the rack and slide it all the way into the rack. Refer to Figure 3‐1 .
2. Use 4 screws (2 per side) provided with the equipment rack to secure the chassis to the rack,
starting with the bottom holes and working toward the top of the chassis, as shown in
Figure 3‐1 .
Figure 3-1 Rack Mounting the Enterasys Matrix N1 Chassis
Attaching the Electrostatic Discharge Wrist Strap
The Electrostatic Discharge (ESD) wrist strap must be attached before handling the modules used
in the Enterasys Matrix N1 Chassis. In addition, observe all precautions when handling these
modules to prevent damage from electrostatic discharge.
Place the ESD wrist strap on your wrist and plug the other end into the grounding receptacle, at
the top right corner of the chassis, shown in
Figure 3‐2 .
Caution: Read Chapter 2 before completing the following procedure to ensure that all installation
guidelines are met.
Precaución: Antes de llevar a cabo el siguiente procedimiento, lea Chapter 2 para y asegúrese
de cumplir con todos los requisitos de instalación.
Warning: To help prevent personal injury, at least two people are required to lift the chassis into
the rack.
Advertencia: Para ayudar a prevenir alguna lesión personal, al menos dos personas son
requeridas para levantar el chasis y meterlo al rack.
Warnhinweis: Zum Schutz vor körperlichen Schäden, sollten sie mit min. zwei Personen das
Chassis in das Rack heben.
1 Rails of 19-inch rack 2 Mounting screws (supplied by user)
Note: The Enterasys Matrix N1 Chassis must not exceed the 2U high rackmount standard and
must comply with the requirements for mounting in a 19-inch (48.26-centimeter) rack.
2
1 1
2
FAN STATUS PS1 STATUS PS2 STATUS
N1 GROUND STRAP
7C111