Enterasys Networks 7S4280-19-SYS - Manual (Page 25)

Overview
Enterasys NAC Controller Hardware Installation Guide 1-5
The 7S4280-19 NAC Controller PEP
The 7S4280‐19 NAC Controller PEP has 20, 1000BASE‐X compliant front‐panel ports that support
a variety of optional Small Form Factor Pluggable (SFP) Gigabit connections using optional
Mini‐Gigabit Interface Cards (Mini‐GBICs).
The 7S4280‐19 is installed in the Enterasys Matrix N1 chassis.
Figure 1-2 7S4280-19 NAC Controller PEP
1 OFFLINE/RESET switch 7 GROUP SELECT LEDs 13 VGA port
2 RJ45 COM port 8 Mini-GBIC Gigabit port slots (2) 14 RS232 serial COM port
3 CPU LED 9 Gigabit port link/activity LEDs 15 CPU power LED
4 MGMT LED 10 USB port 16 CPU reset button
5 GROUP SELECT button 11 10/100 Ethernet port link LED 17 Hard drive activity LED
6 GROUP STATUS LEDs 12 10/100 Ethernet port (see Note below) 18 10/100 Ethernet port activity LED
19 Ports (1-18), 1000 Mbps, through
optional MGBICs
Note: The 10/100 Ethernet port is for management purposes only. If you want network
connectivity, you need to connect to one of the 1000 Mbps ports as shown in
Figure 1-2 .