Enterasys Networks 7S4280-19-SYS - Manual (Page 30)

Configuration Guidelines
2-2 Installation Requirements and Guidelines
Configuration Guidelines
The NAC Controller PEPs for the Enterasys NAC Controller are equipped with a firmware‐based
management tool, which provides the capability to configure the NAC Controller PEP and access
chassis, power supply, and fan information.
LANVIEW LEDs
The following sections describe the LANVIEW LED indications for the following:
• Enterasys NAC Controller power supplies
• Enterasys NAC Controller fans
Power Supply LEDs
There are two power supply LEDs on the front panel of the chassis, one for each power supply.
Refer to
Figure 2‐1 for the location of the power supply LEDs. Table 2‐1 describes the different
states of the power supply LEDs under different conditions.
Figure 2-1 Power Supply LEDs
1 PS1 LED 2 PS2 LED
Table 2-1 Power Supply (PS) LED Status Definitions
Condition PS1 PS2 PS1 LED PS2 LED
1 ON ON Green Green
2 ON OFF Green Red
3 OFF ON Red Green
FAN STATUS PS1 STATUS PS2 STATUS
N1 GROUND STRAP
7C111
1 2