Installing the dimm – Enterasys Networks 7S4280-19-SYS User Manual

Page 104

Memory Locations and Replacement Procedures

B-4 Mode Switch Bank Settings and Optional Installations

Installing the DIMM

To install a DIMM, refer to

Figure B‐4

and proceed as follows:

Insert the DIMM down between the connector fingers.

Pivot the DIMM downward so the tabs on the connector arms align with the two DIMM
alignment notches. With the two connector arms spread outward, push the DIMM down
between the connector arms. Then release the two connector arms to lock the DIMM into
place.

Figure B-4 Installing the DIMM

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.

1 DIMM

3 Connector arms

2 Connector fingers

4 DIMM alignment notches (2)

This manual is related to the following products:

2S4082-25-SYS