Enterasys Networks 7S4280-19-SYS - Manual (Page 82)

The NAC Controller Initialization Procedure
6-14 Initializing the NAC Controller
Figure 6-19 Select the UTC/Local Hardware Clock Setting
If your system hardware clock is set to local time, go to Step 14 . If your system hardware clock
is set to UTC, go to Step 15 .
14. If your system hardware clock is set to local, the timezone configuration screen displays as
displayed in Figure 6‐20 . Select the desired timezone and click OK to proceed.
Figure 6-20 Timezone Configuraiton
15. A screen appears allowing you to enable an SNMP daemon. To monitor the NAC Controller
using SNMP click on Yes as displayed in Figure 6‐21 to proceed, otherwise click on No. If you
click on No, the display performs some processing and returns to the system prompt.