NEC MA Series 43" 4K Commercial Display with Media Player and Raspberry Pi Compute Module 4 SoC - Manual (Page 28)

English−24
Wireless Remote Control
1
NOTEN: The buttons with no explanation are not used with
your monitor model.
1 POWER ON and STANDBY Buttons
POWER ON resumes full power from low power mode.
STANDBY puts the monitor in low power mode.
See
page 33 .
2 INPUT Button
Cycles through the available inputs.
These are available inputs only, shown as their factory
preset name.
3 OPTION MENU Button
For use when an Option Board is installed. See page 22 .
The function depends on which Option Board is installed in the monitor.
4 KEYPAD
Press the buttons to set and change passwords, change the
channel and set the REMOTE ID. See
page 58 .
Some buttons are used for CEC (Consumer Electronics
Control).
5 ENT Button
Makes selections.
For use with an Option Board. The function depends on
which Option Board is installed in the monitor.
Some buttons are used for CEC (Consumer Electronics
Control).
6 DISPLAY Button
Shows/Hides the information OSD. See page 38 .
Unlocks the remote control’s buttons if they have been
locked in the [LOCK SETTINGS] in the [PROTECT] menu.
Press and hold the DISPLAY button for more than five
seconds to unlock the remote. See
page 51 .
7 MENU Button
Opens and closes the OSD menu. See page 38 .
8 EXIT Button
Acts as a back button within the OSD to move to the
previous OSD menu.
Acts as an EXIT button to close the OSD menu when on the
main menu.
9  /  Button (up/down button)
Act as navigation buttons, within the OSD menu to move the
highlighted area up or down.
0 –/+ Button (minus/plus button)
Act as navigation buttons, within the OSD menu to move the
highlighted area left or right.
Increases or decreases the adjustment level within the
selected OSD menu setting.
! SET/POINT ZOOM Button
SET: When the OSD menu is open, this button acts as a set
button when you make a selection.
POINT ZOOM: When the OSD menu is closed, this button
acts as a point zoom button. See
page 37 .
@ VOLUME +/– Button
Increases or decreases the audio output level.
# CH/ZOOM +/– Button*
Increases or decreases the point zoom level. Please refer to
the Point Zoom instructions. See
page 37 .
*: When using with an Option Board, the function depends on which Option
Board is installed in the monitor.
$ GUIDE Button
For use with an Option Board. The function depends on
which Option Board is installed in the monitor.